Motorola Symbol LS1203 - Appendix A Standard Defaults; All Default Parameters

Appendix A Standard Defaults
Table A-1 All Default Parameters
Parameter Default Page Number
User Preferences
Set Default Parameter Restore Defaults 4-3
Beeper Tone Medium 4-4
Beeper Volume High 4-4
Power Mode Continuous On 4-5
Scan Line Width Full Width 4-6
Laser On Time 3.0 Sec 4-6
Beep After Good Decode Enable 4-7
Transmit Code ID Character None 4-7
Prefix Value 7013 <CR><LF> 4-8
Suffix Value 7013 <CR><LF> 4-8
Scan Data Transmission Format Data As Is 4-8
FN1 Substitution Values Set 4-10
Transmit “No Read” Message Disable 4-10
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type
IBM PC/AT& IBM PC Compatibles
1
5-4
Country Types (Country Codes) North American 5-5
Ignore Unknown Characters Send 5-6
1
User selection is required to configure this interface and this is the most common selection.