4 - 2 Symbol LS1203 Product Reference Guide
Errors While Scanning
Unless otherwise specified, when an error is made during a scanning sequence, just re-scan the correct
parameter.
User Preferences Parameter Defaults
Table 4-1 lists the defaults for user preferences parameters. To change any option, scan the appropriate bar
code(s) provided in the User Preferences section beginning on page 4-3.
NOTE See Appendix A, Standard Defaults for all user preferences, hosts and symbologies default
parameters.
Table 4-1
User Preferences
Parameter Default Page Number
User Preferences
Beeper Tone Medium
4-4
Beeper Volume High
4-4
Power Mode Continuous On
4-5
Scanning Mode Triggered
4-5
Scan Line Width Full Width
4-6
Laser On Time 3.0 Sec
4-6
Beep After Good Decode Enable
4-7
Transmit Code ID Character None
4-7
Prefix Value 7013 <CR><LF>
4-8
Suffix Value 7013 <CR><LF>
4-8
Scan Data Transmission Format Data as is
4-8
FN1 Substitution Values Set
4-10
Transmit “No Read” Message Disable
4-10
To Next Page
Loading...
