13 - 6 Symbol MT2070/MT2090 User Guide
Prior to inserting the device in the cradle, it is recommended that you turn off the device’s wi-fi radio to avoid
interference. To turn off the radio, go to the Home screen on the device and select Config > Wireless Companion >
Disable Radio.
Charging
To charge the battery in the device and/or a spare battery, ensure the correct power supply is connected then place
the device/battery in the cradle (see Inserting Batteries on page 13-7). Charging begins when the LED indicators,
on the device and in the cradle’s spare battery section, start flashing green. A complete charge of a fully
discharged battery can take up to four hours.
LED Indicators
Table 13-4
Device LED Indicators
LED Indication
Off No power applied to device (battery discharged or removed); device is in low power and ready to
scan; or, battery is fully charged and device is ready to scan.
Green Flash Device is charging.
Red Flash Charging problem or data transmission problem.
Table 13-5
Cradle LED Indicators
LED Indication
Solid Blue (Cradle Power LED) Cradle is powered.
Ethernet Activity LEDs
(Ethernet cradles only)
Speed LED (100/10) - Primary Port Connection
The cradle’s green Speed LED lights to indicate that the transfer rate is 100 Mbps. When it
is not lit it indicates that the transfer rate is 10Mbps.
Link LED ( ) - Primary Port Connection
The cradle’s amber Link LED blinks to indicate activity, or stays lit to indicate that a link is
established. When it is not lit it indicates there is no link.
To Next Page
Loading...
