14 - 30 Symbol MT2070/MT2090 User Guide
Move Cursor
Scan a bar code below to move the cursor in relation to a specified character. Then enter a character by scanning
a bar code from the Alphanumeric Keyboard on page 14-89.
Send Pause
Scan the bar code below to insert a pause in the transmission of data. See Pause Duration on page 14-7 to set the
length of this pause.
NOTE If there is no match and the rule fails, the next rule is checked.
Move Cursor To Character
Move Cursor To Start
Move Cursor Past Character
To Next Page
Loading...
