Chapter 13 Accessories
Introduction
The MT2070/MT2090 accessories provide a variety of product support capabilities. This chapter provides
information about cables, single slot cradles, multi-slot cradles and the four slot battery charger.
Table 13-1
Accessories
Accessory Description
Cradles
Single slot charge only cradle STB2000-C10007R single slot charge only with ActiveSync cradle charges the
device’s Li-ion battery installed in the device. It also synchronizes the device with a
host computer using ActiveSync through a USB connection.
Single slot charge/multi-interface
Bluetooth cradle
STB2078-C10007WR single slot multi-interface Bluetooth cradle charges the
device’s Li-ion battery installed in the device and, when the pairing bar code on the
cradle is scanned, it pairs with the device allowing the device and cradle to
exchange information.
Note: ActiveSync is not supported on this cradle.
Single slot forklift cradle. STB2000-F10007R forklift single slot charge only cradle charges the device’s Li-ion
battery installed in the device. The following accessories are not included but may
be required: 9 Vdc, minimum 2A power supply for forklift configuration (Motorola part
number 50-14000-122R); three 1.25" #8 Phillips head screws (for wall mounting, if
applicable, not available from Motorola).
Four slot charge only cradle STB2000-C40007R four slot charge only cradle charges up to four spare batteries
and up to four devices with batteries installed.
Four slot charge/Ethernet cradle STB2000-C40017R four slot Ethernet cradle charges up to four spare batteries and
up to four devices with batteries installed. It also synchronizes up to four devices
with a host computer through an Ethernet connection. An Ethernet cable is required
for communication (not available from Motorola).
Battery Charger
Four slot spare battery charger SAC2000-4000CR four slot spare battery charger charges up to four single
batteries.
To Next Page
Loading...
