of 51 GSM Field Service Support
29
T200 / T2688
6.6 Testing on DM TOOLS
Below is the power up screen on selecting DM Tools.
File Types:
Boot file is of type .mot and the naming protocol is of the form r_amdt.mot
Flash file is of type .mot and the naming protocol is taken from the s/w version
As seen above 70131411.mot
Database file is a binary (.bin)type and the naming protocol is also derived from
The s/ware version e.g. 701314.bin
First select options from tool bar then:
Set comm port either 1 or 2 (the gray dot indicates selected port).
Set baud rate 19200 to allow flexing access.
Set eeprom mode default.
Remove charger jack from download box.
Note:
To upgrade the s/w from 701205 to 701214 you must use the database file, associated with the older
version (701205). So in the Choose Database File you would choose 701205.bin instead of 701214.bin
To then use flexing tools, the database should be changed to the later version, in this case 701214.bin
The software for the T205 is 7013xx and for the T200 it is 7012xx
The selection of the Boot file is as above
The Flash file is derived from the s/w version as above
To Next Page
Loading...
