Need help?Do you have a question about the Motorola T9000 and is the answer not in the manual?
General| Channels | 22 |
|---|---|
| Privacy Codes | 121 |
| Range | Up to 25 miles |
| Power Source | Rechargeable battery |
| Weather Alerts | Yes |
| Frequency Range | FRS/GMRS |
| Weight | 0.43 lbs (195 g) |
Controls RF exposure by limiting transmission time to ensure compliance with general population limits.
Use only supplied or approved antennas to prevent damage and FCC regulation violations.
Hold radio vertically with microphone 1-2 inches from lips for clear transmission.
Use approved accessories or maintain 1-inch distance for FCC RF exposure compliance.
Details GMRS licensing, FCC rules, and device compliance statements for proper operation.
Power the radio on by turning the volume button clockwise and off anticlockwise.
Press and hold 'Mon' to check channel activity before transmitting to avoid interruptions.
Displays remaining battery power and provides a warning when the battery is low.
Hold radio 5-7 cm from mouth, press PTT to speak, release to receive.
Use the volume button to adjust audio to a comfortable listening level.
Use MENU, +/-, and PTT buttons to select channels and interference eliminator codes.
Prevents accidental transmissions by stopping after 60 seconds of continuous PTT press.
Press and hold MENU for three seconds to lock or unlock the keypad.
Monitor channels for activity; stops on detected transmissions and allows response.
Resume scanning or temporarily remove undesired channels from the scan list.
Transmit hands-free by speaking into the accessory microphone; disabling by PTT or accessory removal.
Internal VOX feature allows hands-free operation using the radio's microphone.
Adjust VOX, IVOX, or microphone sensitivity for optimal voice or noise detection.
Enable vibrate alert for incoming transmissions for discreet notifications.
Red LED flashes to indicate that the selected channel is currently in use.
Set call tones to alert others or enable roger beep for transmission confirmation.
Press MENU to show '00' '00', then press '+' to start the stopwatch.
Use '+' to pause/resume, '-' to reset. Displays time, seconds, minutes.
Press PTT, CALL, or MENU to exit stop watch and return to transmitting or standby state.
To Next Page