5
2. The display screen then shows the
current channel, code, and all features that are
enabled.
Setting the Volume
From Standby Mode, press on either or
to show the current value. Press or
again to adjust the volume setting.
1. Press to increase the speaker volume.
2. Press to decrease the speaker volume.
Do not hold the radio close to your ear. If the
volume is set to an uncomfortable level, it could
hurt your ear. Adjust ‘0’ to mute the speaker.
Talking and Listening
All radios in your group must be set to the same
channel and Sub-Code in order to communicate.
1. Hold your radio 2–3 cm from your mouth.
2. Press and hold the PTT button while speaking. The Transmit icon appears on the display.
3. Release the PTT button. You can now receive incoming calls. When you do, the Receive icon appears on the
display.
For maximum clarity, hold the radio 2 to 3 cm away and avoid covering the microphone while talking.
Talk Range
Your radio is designed to maximize performance and improve transmission range. Ensure the radios are at least 5
feet apart when in used.
Monitor Button
Pressing and holding Scan/Monitor for 3 seconds to enter Monitor mode and listen for weak signals on the current
channel. You can also listen to the volume level of the radio
To Next Page
Loading...
