43
DMO Group Call
• None: the MTP850 will not use a gate-
way for that talkgroup.
• Automatic: the MTP850 will use the first
available gateway for that talkgroup. The
Gateway icon will flash until the terminal
finds an available gateway.
• Specific: the MTP850 will use a specific gateway for
that talkgroup.
Upon selecting “Specific”, you will see one of the follow-
ing displays:
> The selected gateway address (e.g.:
1022), pre-programmed by your Serv-
ice Provider or previously entered by
yourself via the keypad. Press
Ok to
use the current address, or enter a
new address via the keypad, and
press
Ok. The Gateway icon will flash until the termi-
nal finds an available gateway.
>“None”, indicating that no specific
gateway was selected for that talk-
group. Enter an address via the key-
pad, and press
Ok. The Gateway icon
will flash until the terminal finds an
available gateway.
Pressing
Back causes the following message to be
displayed for a few seconds: “No Specific Gateway Was
Selected”. The MTP850 exits the Gateway menu option
and the previous gateway type will be selected.
When the MTP850 is synchronised with the gateway, the
Gateway icon will be solid.
3. To place the call, proceed as explained on page 42.
• If you press
PTT while the gateway is not available, you
will start a DMO call without gateway. The Gateway icon
will disappear.
GW Options
Automatic
Specific
None
Select Back
Selected
Gateway:
1022
Ok Back
Selected
Gateway:
None
Ok Back
6866537D80-A.book Seite 43 Freitag, 29. Juli 2005 4:15 16
To Next Page
Loading...
