Motorola v3i - Page 38

38 November 18, 2005 6809495A82-A
Disassembly V3i
5. Carefully and gently lift one corner of the display module assembly out of the
flip assembly.
6. Avoid damage to the electrical components on the flex while carefully removing
the display module assembly from the flip assembly.
7. Carefully lift the display lens away from the flip assembly.
8. To replace, align the display module assembly to the flip assembly.
9. Carefully lower the display module into the flip assembly. Ensure that none of
the display assembly components are damaged.
10. Align the flip display flex to the flex connector on the flip display assembly and
gently press down on the flex connector until properly seated.
11. Replace the camera assembly, flip assembly cover, transceiver board, rear
housing, antenna, SIM, battery, and battery cover as described in the
procedures.
051165o
Figure 17. Display Module Assembly Removal
Di
sp
l
ay mo
d
u
l
e assem
bl
y
Disassembly tool