Getting More Out Of Your Phone - 117
Attach a USB Cable
Send a Data or Fax Call
Use this procedure to send data or a fax from a connected device,
and to synchronise phonebook and datebook information between
your phone, computer, and/or hand-held device.
Connect your phone to the device as described on page 115 and
do the following:
Do This
1 Plug the end of the
cable with the Motorola
logo into the phone’s
accessory connector
port. Make sure that the
logo and the phone are
both facing you.
2 Plug the other end—the USB connection—into the
USB port on the external device.
Do This To
1 Check the phone make sure that the phone is
connected and powered on
2 Open the
application on
your computer
place the call through the
application (such as
dial-up-networking or fax)
Note: You cannot dial data or
fax numbers through your
phone’s keypad. You must dial
them through your computer,
unless you are making a talk
then fax call (see page 118).
UG.GSM.book Page 117 Thursday, June 6, 2002 2:22 PM
To Next Page
Loading...
