CONFIGURATION SECTION 3
SECTION 3, CONFIGURATION 3-37
Field Description
Firewall Click to disable the Firewall. The default is
enabled.
Multicast
Pass-through
Click to enable Multicast Pass-through. The
default is disabled.
To add a Packet Filter entry:
1 Packet Filter Name: Enter a descriptive name.
2 Filter Action: Select Allow or Deny. Allow: permits data that meets
the criteria selected. Deny: blocks the data that meets the
selected criteria.
3 Packet Direction: From the drop down box, select either Inbound
or Outbound, based on whether you want to monitor incoming or
outgoing packets.
4 Packet Protocol: Select the type of protocol to monitor, TCP,
UPD, ICMP, or ALL.
5 Source IP Range: Enter the IP range.
6 Source Port Begins and Ends: Enter the Port range.
7 Destination IP Range: Enter the Destination IP range.
8 Destination Port Begins and Ends: Enter the Destination Port
range.
9 Click Add to add the entry.
To Next Page
Loading...
