Wireless Applications 5 - 7
Ad-Hoc
Use the Ad-Hoc dialog box to select the required information to control Ad-Hoc mode. This dialog box does not
appear if you selected
Infrastructure mode. To select Ad-Hoc mode:
1. Press Tab to highlight the Channel drop-down list.
2. Use the navigation keys to select a channel number. The default is Channel 1 (2412 MHz).
Figure 5-5
Ad-Hoc Settings Dialog Box
3. Press TAB twice to highlight the Next button.
4. Press ENTER. The Encryption dialog box displays. See Encryption on page 5-15 for encryption options.
Authentication
Use the Authentication dialog box to configure authentication. If you selected Ad-Hoc mode, this dialog box is not
available and authentication is set to
None by default.
1. Use the navigation keys to select an authentication type from the drop-down list.
2. Press TAB twice to highlight the Next button.
3. Press ENTER.
Selecting
PEAP or TTLS displays the Tunneled dialog box. Selecting None, TLS, or LEAP displays the Encryption
dialog box. See Encryption on page 5-15 for encryption options. Table 5-6 lists the available authentication options.
To Next Page
Loading...
