Getting Started 1 - 9
Charging Spare Batteries
Use the following accessories to charge spare batteries:
•
Single Slot USB Cradle
•
Four Slot Spare Battery Charger.
To charge a spare battery:
1. Ensure the accessory used to charge the spare battery is connected to the appropriate power source.
2. Insert the spare battery into the accessory’s spare battery charging slot with the charging contacts facing down
(over the charging pins) and gently press down on the battery to ensure proper contact.
3. The battery starts to charge automatically. The amber charge LED on the accessory lights to show the charge
status. See Chapter 3, Accessories for accessory charge LED indicator definitions.
The standard capacity battery fully charges in less than four hours and the extended capacity battery fully charges
in less than eight hours.
Removing the Main Battery
To remove the main battery:
1. Prior to removing the battery, ensure that the wearable terminal is in suspend mode. If the wearable terminal is
not in suspend mode, press the Power button to place the wearable terminal in suspend mode.
2. Press the battery release button. The battery partially ejects from the wearable terminal.
3. Remove the battery from the wearable terminal.
Figure 1-8
Removing the Main Battery
To Next Page
Loading...
