to build up inside the unit. Do not use the appliance to grate or mince substances
which are too hard, such as sugar or large pieces of meat. Cut food into small pieces
so that it can be fed easily into the hopper.
COULIS ACCESSORY (depending on model)
This accessory, which is fitted to the top of the mincer, will allow you to make coulis
(red fruit, tomatoes) and juice (apple, pear, orange, etc.).
Fitting (diagram 16):
Position screw M2 in place on the body A1 of the top of the mincer A. Put the coulis
filter into position according to the selected use (mixed-hole filter for coulis M3
or small-hole filter for juice M4. Then position the screw A5 and screw it in place
tightly. Place the top of the mincer fitted with this assembly onto the motor drive
H. Then position the juice guide M5 under the filter fitted into position (M3 or M4).
Note: this accessory is not for use with a grille or a knife.
Use:
Coulis:
Use the M3 filter, which has 2 filter hole diameters for better extraction. To
make coulis, it is essential to only use fresh fruit. Depending on the season
and the quality of the fruit, it is advisable to sieve the pulp twice to extract
the maximum amount of coulis.
Juice: Use the M4 filter, which has only one filter hole diameter. Place a dish to
collect the juice under the juice guide M5 and another at the end of the filter
to collect the waste.
• Always unplug the appliance before cleaning the motor unit (H).
• Do not put the motor unit in water or hold it under a running tap. Clean the
motor unit with a damp cloth and dry it carefully.
1) Mincer accessories:
- Release the head or accessory by pressing button E.
-
Turn the mincer head unit (A) to the right and pull it towards you to remove it
from the motor unit (H).
-
To remove the head unit (A), lift off the pusher (C) and the tray (B), unscrew the
locking nut (A5), remove the screen (A4), the blades (A3) and the screw feeder (A2).
- Take special care when handling sharp components.
- Wash all pieces in warm water and washing up liquid, rinse and dry carefully.
Do not put any parts of the head unit (A) in the dishwasher (main body (A1),
screw feeder (A2), blades (A3), screens (A4), locking nut (A5)).
2) Vegetable cutter and other accessories:
-
The drum holder (L1), the pusher (L2), the drums (L3a, L3b, L3c, L3d) and the
dicer attachment (L3e) can be washed in the dishwasher in the top tray only using
CLEANING:
7