Moulinex LS-123456 Instruction Booklet

Assembly (diagram 6) :
Fit the screw feeder (A2) into the mincer head assembly (A1). Fit the nozzle (K1)
and secure it by tightening the locking nut (A5). When assembled, fit the mincer
head to the motor unit (H).
NB : this accessory is used without a screen or blades.
Use:
Important: this accessory should only be used after you have minced the meat,
added seasoning and mixed the
preparation thoroughly.
Soak the sausage casing in warm water to soften it and slide all of it onto nozzle
(K1) leaving about 5 cm of casing over hanging at the end.
Fill the hopper (A1) on the head assembly (A) with mince, turn the appliance on
and push down with the pusher (C) until the mince reaches the end of the nozzle.
Turn off the appliance.
Tie a knot in the 5 cm length of free casing. Slide the knot up to the end of the
nozzle so that air is not trapped in the casing.
Turn the appliance on again and continue to add mince. Ease the casing along as it
fills. Do not overfill the sausages as this will stretch the casing.
NB : this operation is easier if two people do it together, one feeding the mince
into the mincer and the other holding the casing in position as it fills.
Make sausages of the desired length by pinching the casing and twisting it where
appropriate.
For the best results take care to prevent air becoming trapped in the casing during
filling and make sausages 10 cm to 15 cm in length (separate the sausages by tying
a knot round the casing).
VEGETABLE CUTTER (L)
Assembly (diagram 7):
The motor unit must be unplugged. Position the vegetable cutting unit (L1) in front
of the motor unit tilted to the right so that the lugs are aligned with the notches in
the motor unit (H). Insert the shaft of the unit in the centre hole of of the motor
unit (H). Turn the hopper to the left until the unit (L1) clicks home with the hopper
in the upright position.
Use:
• Select the drum you wish to use.
•
Fit the drum into the opening at the front of the vegetable cutter (L1), ensuring
that it is pushed firmly home (Fig. 8).
• Plug in the appliance.
• Press the On / Off button (F) once or twice to lock the drum into position (Fig. 9).
• Start the appliance and feed the vegetables into the hopper (L1) (Fig. 10), pushing
them down with the pusher (L2) (Fig. 11).
• To change the drum, wait for the appliance to stop completely and then press the
Reverse button (G) for 1 second. The drum will be released automatically (Fig. 12).
5

Moulinex LS-123456 Specifications

General

Brand	Moulinex
Model	LS-123456
Category	Meat Grinder
Language	English