Mountz MDC-26 - Page 11

5.3 Auto Speed by torque setting under the each test condition
◆ Speed range : Speed can be set manually
◆ Auto speed by torque setting : Auto Speed helps reduce the effect that RPM has on the
application based on testing conditions and joint characteristics listed in the charts below.
259
rpm
2000
Kgf.cm
7.0 0.5
MD2601
428
2.7 4.0
Kgf.cm
rpm
2000
0.3
M3 rundown
Hard j
oint 150Hz
M3 rundown
Hard joint 500Hz
M3 rundown
Hard joint 500Hz
M4 rundown
Hard joint 500Hz
M4 rundown
Hard joint 500Hz
M4 rundown
Hard joint 500Hz
150
150
1340
MD2602
MD2604
235
14
Kgf.cm
rpm
1500
1.5
1330
150
MD2611
93 34
Kgf.cm
rpm
900
4
694
100
MD2616
118
50
Kgf.cm
rpm
620
5 40.4
100
mountztorque.com - 1080 N 11th St, San Jose CA 95112 - 408.292.2214
11