2 Issue 03.2024
MPK Metall- und
Plastikverarbeitung GmbH & Co. KG
Friedrich-Ebert-Str. 298-300
D-58566 Kierspe
mpk-rooflights.com
Installation
Please clean the frames carefully before mounting the
sealant. Remove dirt, grease, oil or release agents from the
assembly area.
Follow the instructions of the sealant manufacturer.
Separate the inner and outer frames and fit the outer frame
to the outside of the roof aperture onto a bed of sealant.
The operating handles facing the front and rear of the
vehicle!
Remove the mosquito net before proceeding with the
installation of the inner frame.
The mosquito net is clipped on and can be pulled downwards
when open.
Do not tilt to avoid damage!
Correctly align the upper and inner frame and secure evenly
with the screws.
Max. Torque 0.5 Nm.
Make sure that the recesses of the mounting frame are on the
sides of the handles.
Put the mosquito net back on and close it.
Operation
To open the rooflight, press both locking buttons and push the handles upwards.
The rooflight can be opened fully by the handles or in four different directions, so that the
dome can be angled against driving weather conditions.
To close the rooflight, press the locking buttons again and pull the handles down. The
rooflight is locked.
Cleaning
For easier cleaning of the dome it can be removed from the frame
by releasing the four screws holding the handle arms.
Never remove the screws holding the dome and the
handles together. These are secured by a torque
screwdriver and should only be handled by an approved
dealer.
Use only clear water and a soft sponge.
Solvents may attack the plastic and make it brittle.
Clean the gaps by immersing the hood in a container filled with water. Let the dirt soak a
little. Use the two handles to pull the hood through the water so that the dirt can be washed
out.
Make sure that only the original screws are used when replacing the dome and they
enter the thread in the plastic correctly. Do not over-tighten.
Warranty
The legal warranty applies.
Disposal
Dispose of packaging material and product in accordance with local legal regulations and
regulations for the disposal of plastics.
To Previous Page
Loading...