Need help?Do you have a question about the M+S MM Series and is the answer not in the manual?
Procedure for disassembling hydraulic motors, including initial preparation and removal of components like flange and end cover.
Instructions for removing the plate, O-rings, and the roll-gerotor set from the hydraulic motor assembly.
Steps to remove the cardan shaft and distributor plate from the hydraulic motor.
Procedure for removing the front cap, dust seal, and shaft seal from the hydraulic motor housing.
Guidelines for cleaning motor parts, measuring dimensions, and replacing worn components during disassembly.
Instructions for lubricating seal parts with petroleum jelly during the reassembly process.
List of available seal kit part numbers for MM and MLHM hydraulic motors.
Steps for lubricating and assembling the output shaft, needle bearing, and thrust washer into the motor housing.
Procedure for installing shaft seal, dust seal, and O-ring into the front cap during reassembly.
Instructions for fitting the front cap assembly onto the motor housing and securing it with screws.
Steps for installing the cardan shaft and distributor plate, including O-ring lubrication and alignment.
Procedure for placing the gerotor set onto the distributor plate, aligning key grooves, and installing balls.
Instructions for installing various end covers (S, PL(R), D) and securing them with screws and Loctite.
Procedure for installing the drain plug with its washer and O-ring, and tightening specifications.
Specific steps for reassembling F-flanged motors, including flange screw torque.
Procedures for motors with integrated crossover relief valves, covering disassembly of valve seat and plug.
To Next Page
General