13
EN
3. Once the wafer maker heats up sufficiently, the LED indicator will turn green. Depending on
the type of batter and baking goal, use the knob
4
to set the temperature of the cooking
plates. The “MIN” setting corresponds to the lowest available temperature, while the “MAX”
setting corresponds to the highest one. It is also possible to set any intermediate tempera-
ture between “MIN” and “MAX”. While the wafers are being made, the LED indicator in the
knob (4) will change its colour multiple times to indicate that cooking plates’ temperature is
maintained.
4. Open the top lid
2
, place the dough onto the bottom heating plate
1
and gently close the
lid.
5. When closing and opening the lid, proceed carefully owing to hot vapours escaping from the
sides of the waffle-maker.
6. Baking the waffles may take from 5 to 10 minutes, depending on the batter and set temper-
ature.
7. Open the top lid
2
, take out the waffles using wooden or plastic spatula only.
NOTE! Do not use and metal and sharp knifes or forks, otherwise the damages of heating surfaces may occur!
8. After baking turn the thermostat knob to “0”, pull out the plug from the outlet and allow the
appliance to cool down completely.
CLEANING AND MAINTENANCE
1. Before cleaning (and after baking), pull out the plug from the outlet and allow the appliance
to cool down completely.
2. Thoroughly wash the heating plates
1
using damp cloth or towel.
3. Wipe the external surface of the waffle-maker using wet cloth.
NOTE! Do not immerse the appliance in water or any other liquids! Do not wipe the inside of the appliance with
acute, abrasive cloths or sponges, as this can damage the heating surfaces!
TECHNICAL DATA
See the product’s nameplate for technical specifications.
Length of power cord: 0.80 m
PROPER DISPOSAL OF THE PRODUCT (waste electrical and electronic equipment)
Poland
Marking on the product indicates that after the service-life of the product expires, it should not be disposed
with other type of municipal waste. Used equipment may have a negative impact on the environment
and health of people due to potentially containing hazardous substances, mixtures and components. Mixing
electric waste with other types of waste or disassembling those in an unprofessional manner may cause
a release of substances that are hazardous to the environment and health. Used equipment should be hand-
ed-over to a point for collection of electric waste. In order to obtain detailed information regarding the electric waste col-
lection points, the user should contact the municipal point of electric waste collection or used equipment processing de-
partment.
To Next Page
Loading...
Need help?
General
