3. MAINTENANCE
It is recommended that the thermoelectric refrigerator shall be cleaned before its operation!
Clean the refrigerator with soft cloth with water and neutral detergent, then to wash inside and
outside the refrigerator with clean water, then wipe the refrigerator dry.
After operation of the refrigerator, remove the dust on the cooling system on back of the
refrigerator with soft cloth or feather duster at irregular intervals.
Clean the water storage tank on the back of the refrigerator every quarter or at irregular
intervals. The dismount steps of the water storage tank
before cleaning as the following figure.
When it is necessary to clean the shelves on the door, only
lift the shelves up, then take the shelves out.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
4. METHOD OF OPERATION
The refrigerator appilies automatic defrosting system, so there is no
need to defrost it manually.
Put articles into the refrigerator 2-3 hours after switch on and inside
chamber is cooled down.
It is suggested that the best refrigeration temperature is about 12°C
(When the temperature control knob points to the position shown in
the figure)
The shelves can be freely adjusted conducive to store articles with
various sizes.
There is a light inside the chamber of the refrigerator; the light will be automatically on when
the door of the refrigerator is open LIGHTING.
CHANGING THE SWING HINGE
This refrigerator has the capability of the door opening from either the left or right side. The
unit is delivered to you with the door opening from the left side. Should you desire to reverse
the opening direction, please follow the below instructions.
Pull out the two screws from right hinge.
Remove the hinge (upper and lower) away.
Install the door in suitable position with hinges, use two screws to fix them.
DISCONNECT THE POWER SUPPLY BEFORE REPLACING THE LIGHT!
Steps for replace light are as follows: unplug the power plug; remove the transparent light
cover on the top of inside chamber; turn the burnt light anti-clockwise and take the burn light
out; fit a new light and turn tight clockwise; put the light cover back. Do not attempt to repair
yourself but call the Authorised Service Agent if the LED illumination lamps do not go on.
Water storage tank
16
EN
To Next Page
Loading...
Need help?
General
