6E
4B
Position the router in front of the
CRB7, aligning router base rod
drilling (A) with Adjuster Rod (5).
Using a 1/2” (13mm) spanner, slightly
loosen Fixed Rod Nut (6E) and Micro
Adjuster Nut (4B).
QUICK SET-UP GUIDE
Check that the router cutter will align
within the Letterbox cross hatched
area.
IF IT WILL, GO TO STEP 6.
IF IT WILL NOT, GO TO STEP 5.
Router
cutter
3
4
Aligned
5
5
6
1
ITEMS REQUIRED:
1. 2 x 1/2” (13mm) A/F open ended
spanner.
2. 1 x 5/16” (8mm) A/F open ended
spanner.
SET-UP TIPS:
1. Positioning the router base wing
bolts at the Bridge end of the
CRB7 will increase Micro Adjuster
accuracy (see step 3).
2. Using 2 x 1/2” spanners when
tightening the Fixed Rod Nuts will
prevent the rod setting being
disturbed (see step 8).
3. When performing the CRB7
set-up, use yor largest router
cutter. If that fits no further
adjustment will be needed for
smaller router cutters.
Router
cutter path
Wing bolt
A
The CRB7 is fitted with 5/16” (8mm)
diameter Guide Rods (5 & 6).
If your router base rod drillings are
smaller, fit the 9/32” (7mm) Guide
Rods, supplied.
2
GUIDE ROD SELECTION INITIAL ALIGNMENT
LOOSEN THE LOCK NUTS
SAFE CUTTER ALIGNMENT
* 1/4”
Clearance
*
CRB7
IMPORTANT:
It is not essential to center the
router cutter precisely within the
CRB7’s Letterbox for ANY
operation.
Letterbox
To Next Page
Need help?
General
