MARINE RADIO CO.,LTD.
주/선박무선
Subject : Auto Exchanger Page : (32 / 44)
Date : 2010.10.06 Doc. : Matex-2000_ENG(Rev. 1.0)
(QAS-ADD-008/0/09.09.25) manual\pabx\matex-2000\Matex-2000_eng.doc
(
MARINE RADIO CO., LTD.)
MRC
1. Programming Guide
1.1 Program function.
1) Function of changing & editing extension number.
2) Function of changing dial
3) Function of setting making automatic connection to outgoing call.
4) Function of setting "Group Call"
5) Function of setting "Priority Call"
6) Function of setting password and etc.
1.2 Description of key phone
1) LCD Display Module
2) DOWN : Search Down Key
3) UP : Search Up Key
4) SET CID : Set the Caller ID
5) BREAK IN : Call Involved Button
6) RELEASE : Forced Termination Button
7) CONFERENCE CALL
8) MONITOR : Call Monitor Button
9) VOL : Volume Control Button
10) ABBREV : Abbreviation Button
11) HOLD : Hold Button
12) PAGE : PAGE Button
13) SPEAKER
14) MUTE
15) TRANS : Call Forwarding Button
16) REDIAL
17) Dial 10-Key Pad
18) CANCEL
19) MESSAGE
1.3 Precaution for programming MATEX-2000
After system is installed, initially programming is needed as follows
※ Year, Date & Time will be displayed in LCD panel as picture below
After power on, the date and time displays on the LCD window.
Standard window:
Year/Month/Day/Day of the Week, Hour: Minute
ST(Extension) Extension Number(Port) Rank
1.3.1 Set Service Code for technician program
Used to open and close technician-level programming. If programming is not opened and an attempt is
made to access a system, the program will not change.
A program access code is required to access this system. Each character can be digits
Ex) **00*000000**
1.3.2 Set System Time
INPUT：HH-MM-SS
NOTE：HH=Hour，MM=Minutes，SS=Second，Use 24Hour mode.
Refer command: **11*HHMMSS
08/08/24/3 19:50
ST 1113(113) N98
**00*000000**
**11*HHMMSS
To Next Page
Loading...