Safety RegulationsMSA
ALTAIR 4
GB
5
1 Safety Regulations
1.1 Correct Use
The ALTAIR 4 Multigas Detector is intended for use by trained and qualified per-
sonnel. It is designed to be used when performing a hazard assessment to:
- assess potential worker exposure to combustible and toxic gases and vapours
as well as low level of oxygen.
- determine the appropriate gas and vapour monitoring needed for a workplace.
The ALTAIR 4 Multigas Detector can be equipped to detect:
- Combustible gases and certain combustible vapours
- Oxygen-deficient or oxygen-rich atmospheres
- Specific toxic gases for which a sensor is installed.
It is imperative that this operating manual be read and observed when using the
product. In particular, the safety instructions, as well as the information for the use
and operation of the product, must be carefully read and observed. Furthermore,
the national regulations applicable in the user's country must be taken into account
for a safe use.
Alternative use, or use outside this specification will be considered as non-compli-
ance. This also applies especially to unauthorised alterations to the product and to
commissioning work that has not been carried out by MSA or authorised persons.
While the instrument can detect up to 25 % oxygen in ambient air, it is
approved for use only up to 21 % oxygen.
Danger!
This product is supporting life and health. Inappropriate use, mainte-
nance or servicing may affect the function of the device and thereby se-
riously compromise the user's life.
Before use the product operability must be verified. The product must
not be used if the function test is unsuccessful, it is damaged, a compe-
tent servicing/maintenance has not been made, genuine MSA spare
parts have not been used.
To Next Page
Loading...
Need help?
General
