1 Safety Notices
1.1 General Notices
• For Declaration of Conformity, please visit the product page on MSAsafety.com.
• This product incorporates Bluetooth wireless technology.
• Alternative use or use outside manufacturer specifications will be considered non-compliance. This also applies to
unauthorized alterations of the product and to commissioning work that has not been carried out by MSA or
authorized persons.
• Use of any charger other than the charger supplied with the device or sold by MSA for use with the ALTAIR io 4 may
damage or improperly charge the battery.
WARNING!
• Cellular connectivity is dependent upon signal availability and strength of the wireless service(s) necessary to
maintain the communication link. Loss of cellular connectivity will prevent remote communication of alerts and other
data from the device to the Grid as well as from the Grid to the device. Low signal strength will delay remote
communication of alerts and other data from the device to the Grid as well as from the Grid to the device. Take
appropriate precautions in the event of a loss of cellular connectivity or low signal strength.
• When cellular connectivity is restored, data from the time period without cellular connectivity is transmitted to the
cloud before the device begins communicating current alerts and data to the Grid. This may result in a delay between
when cellular connectivity is restored and when the device can be monitored on the Grid.
Failure to follow these warnings can result in serious personal injury or death.
1.2 Liability
MSA accepts no liability in cases where the device has been misused, used inappropriately or not used as intended. MSA
accepts no liability in cases where damage or injury is caused by wear and tear, neglect or failure to carry out inspection and
maintenance procedures. The selection and use of the device are the exclusive responsibility of the employer and/or
individual operator. Warranties and guarantees made by MSA with respect to the device are voided, if it is not used,
serviced or maintained in accordance with the instructions in this manual.
The selection and use of this product must be under the direction of a qualified safety professional who has carefully
evaluated the specific hazards of the jobsite where it will be used and who is completely familiar with the product and its
limitations. The selection and use of this product and its incorporation into the safety scheme of the jobsite is the exclusive
responsibility of the employer.
Changes and modifications not expressly approved by the manufacturer will void the user’s authority to operate the
equipment.
Follow all relevant national regulations applicable in country of use.
1.3 Before You Start
WARNING!
Carefully review the following safety limitations and precautions before placing this device in service. Do not alter or modify
the device.
Failure to follow this warning can result in serious personal injury or death.
ALTAIR io 4 4
1 Safety Notices US
To Next Page
Loading...
Need help?
General
