®
Multigas Detector Quick Start Card
l
Turn the instrument ON with the button. Instrument will
warm up and show info & setpoints.
l
FAS: to accept press , to cancel press .
l
Page through screens with button from the Normal
Operation screen.
l
Reset Alarm or PEAK and STEL values press button
l
To perform a Bump Check, press on Bump page.
l
To Calibrate: ensure you are in fresh air and press the
button in Normal Operation mode for more than three
seconds.
TM
l
To activate / deactivate MotionAlert feature (if equipped),
page through screens until MotionAlert screen and press
button.
l
Turn the instrument OFF by holding the button.
WARNING
This quick start card provides only a brief description of the
operating instructions for the ALTAIR 4 Multigas Detector
Alarm. The user of this instrument must be fully aware of the
limitations and instructions supplied in the operating
instruction manual. Failure to follow the instructions may lead
to serious personal injury or death.
709 Rev. 0 1-800-MSA-2222 / www.MSAnet.com 10088365
Please review the back of this card for a detailed illustration
of the following components:
1 Button 2 Button 3 Button
To Next Page
Need help?
General
