Contents
1 Product Description 6
1.1 General 6
1.2 Product Configuration 7
1.3 Theory of Operation 7
1.4 Modes of Operation 7
1.4.1 Classic Sentry Interface 7
1.4.2 Modbus Operation 7
1.4.3 Analog Operation 7
1.4.4 Remote Sensor 7
1.4.5 HART Connection 8
1.4.6 Remote Alarm Reset 8
1.4.7 Optional Integral Relays 8
1.5 Mechanical 8
1.5.1 Enclosure 8
1.5.2 Transmitter Electronics 10
1.5.3 Sensor Assembly 10
1.6 Interconnect Wiring 10
1.7 Power Requirements 10
2 Cautions & Warnings 11
2.1 Introduction 11
2.2 Gas Sensor Modules – General 11
2.3 Wiring Warnings 11
2.4 Calibration Frequency 11
3 Quick Start 12
3.1 Overview 12
3.2 Wiring 12
3.3 Module Installation 12
3.4 Transmitter Installation 12
3.5 Startup and Operation 12
3.6 Zero Stabilization 12
4 Installation 13
4.1 Sensor Module Locations 13
4.2 Wiring 14
4.2.1 Analog 4-20 mA Operation 14
4.2.2 Modbus Operation Using RS-485 Connection 14
4.2.3 Sentry Operation Using Sentry Connection 14
4.2.4 General 15
4.3 Enclosure Installation 15
4.4 Transmitter and Sensor Installation 16
4.5 Module Address Switch 18
5 Operation 24
5.1 Introduction 24
5.2 Data Entry Keypad 24
SMC 5100-XX-IT Toxic Gas Detector Module 3
US
To Next Page
Loading...
Need help?
General
