MSA Ultima X Series Safety Manual

Diagnostic Response Time
The Ultima X Gas Monitor has a diagnostic response time of 24 hours.
This means that any detectable hardware failure is detected and
reported within 24 hours of fault occurrence. This time is equal to the
sum of the diagnostic test interval and the fault response time.
Gas Detection Times
The amount of time it takes to detect the presence of a gas varies
based on sensor type.
• Refer to this information in TABLE 3-1 of the Ultima X Series
Gas Monitor Instruction Manual (P/N 10036101).
Update Time
The state of the analog output and the relay outputs is updated every
second or sooner.
Setup
Installation
For installation, refer to instructions given in chapter 1 of the
Ultima X Series Gas Monitor Instruction Manual (P/N 10036101).
Configuration and Calibration
After installing the Ultima X Gas Monitor, a calibration must be done to
ensure proper operation. Perform the INITIAL Calibration procedure
given in chapter 2 of the Ultima X Series Gas Monitor Instruction
Manual (P/N 10036101).
No gas monitor configuration is required for the analog output.
However, configuration may be required to use the alarm outputs.
• Alarm relays are factory-enabled as non-latching, de-energized.
• Alarm relays activate when the monitor detects a gas concentration
level that exceeds setpoints.
• Factory configuration of alarms 1, 2, and 3 is generally
to set the alarms when 10%, 20%, and 30% of full scale reading
is exceeded, respectively.
2-2

MSA Ultima X Series Specifications

General

Brand	MSA
Model	Ultima X Series
Category	Measuring Instruments
Language	English