MSB Technology The Reference DAC - Page 18

Shielding Ground - Basic Operation
The Basic Operation provides isolation only for the DAC. This gets you
half the shielding available. For full shielding, be sure the jumper is in
place between the Chassis Ground and Amplier Ground. This is the
shipping conguration.
NEVER OPERATE WITHOUT THE JUMPER OR A GROUND WIRE
ATTACHED.
Powerbase - 12 Volt Remote Trigger
The Reference powerbase is equipped with a remote trigger for use
with other MSB products. The trigger uses a 3 pin mini jack. When any
MSB product is turned o, the other products connected will also turn
o and vice-versa. This trigger can also be used with other products.
Products may use this trigger dierently, so you may need an MSB
12Volt trigger adapter.
Reference Powerbase - Advanced Setup
The Reference Powerbase comes with a few features that are not
required for basic operation. These features are mainly used for
altering your system setup and slight ease-of-use improvements. The
12-volt trigger is a network of 3.5mm mini-jack connections that can
make your Reference Powerbase power button turn on/o your MSB
amplier(s) using the power button located on the faceplate or the
power button on your remote to create a single power control for your
entire MSB system. The second feature on the Reference Powerbase
is a ground shield network that can oer a slight increase in sonic
performance by connecting all of your MSB products in a chain and
lifting the chassis ground connections.