A-10
MS-6585 ATX Mainboard
6-Channel Mode for 6-Speaker Output
When this mode is selected, plug the two front speakers to the Line
Out connector on the back panel, and the other two rear speakers to
the Line Out connector on the S-Bracket.
Refer to the following diagram and caption for the function of each
phone jack on the back panel and S-Bracket when 6-Channel mode
is selected.
1 MIC
2 Line In
3 Line Out (Front channels)
4 Optical SPDIF jack
5 Coaxial SPDIF jack
6 Line Out (Center and
Subwoofer channels)
7 Line Out (Rear channels)
Select “Default Phone jack” Deselect “Default Phone jack”
1 Center/Subwoofer Speaker Out
(Center and Subwoofer channels)
2 Rear Speaker Out (Rear channels)
3 Line Out (Front channels)
4 Optical SPDIF jack
5 Coaxial SPDIF jack
6 Line Out (Center and Subwoofer
channels)
7 Line Out (Rear channels)
Back Panel
2
3
1
MSI Reminds You...
If the Center and Subwoofer speaker exchange their audio
channels when you play video or music on the computer, a
converter may be required to exchange center and subwoofer
audio signals. You can purchase the converter from a speaker
store.
S-Bracket
4
5
6
7
To Next Page
Loading...
