Chapter 3
3-20
Integrated Peripherals
USB Controller
This setting is used to enable/disable the onboard USB controllers. Settings:
All USB Port, Disabled, USB Port 0&1, USB Port 2&3.
USB Legacy Support
Set to All Device if your need to use any USB device in the operating system
that does not support or have any USB driver installed, such as DOS and SCO
Unix. Set to No Mice only if your want to use any USB device other than the
USB mouse. Setting options: Disabled, No Mice, All Device.
On-Chip IDE
This setting controls the on-chip IDE controller. Setting options: Disabled,
Primary, Secondary, Both.
Onboard ATA133 RAID Chip (for 845 Ultra-AR/845 Ultra-ARU mainboard)
This allows you to enable/disable the onboard ATA133 RAID controller. Set-
ting options: Disabled, Enabled.
Onboard Audio Chip
This setting is used to enable or disable the onboard audio controller. Setting
options: Disabled, Enabled.
To Next Page
Loading...
