3-10
MS-6743 M-ATX Mainboard
1st/2nd/3rd Boot Device
The items allow you to set the sequence of boot devices where BIOS attempts
to load the disk operating system. The settings are:
Floppy The system will boot from floppy drive.
LS120 The system will boot from LS-120 drive.
HDD-0 The system will boot from the first HDD.
SCSI The system will boot from the SCSI.
CDROM The system will boot from the CD-ROM.
HDD-1 The system will boot from the second HDD.
HDD-2 The system will boot from the third HDD.
HDD-3 The system will boot from the fourth HDD.
ZIP100 The system will boot from ATAPI ZIP drive.
USB-FDD The system will boot from USB-interfaced floppy drive.
USB-ZIP The system will boot from any USB-interfaced ATAPI
ZIP drive
USB-CDROM The system will boot from the USB-interfaced CD-ROM.
USB-HDD The system will boot from the USB-interfaced HDD.
LAN The system will boot from the Network drive.
Disabled Disable this sequence.
MSI Reminds You...
Available settings for “1st/2nd/3rd Boot Device” vary depend-
ing on the bootable devices you have installed. For example, if
you did not install a floppy drive, the setting “Floppy” does not
show up.
MSI Reminds You...
Enabling the functionality of Hyper-Threading Technology for
your computer system requires ALL of the following platform
Components:
*CPU: An Intel
®
Pentium
®
4 Processor with HT Technology;
*Chipset: An Intel
®
Chipset that supports HT Technology;
*BIOS: A BIOS that supports HT Technology and has it enabled;
and
*OS: An operating system that supports HT Technology.
For more information on Hyper-threading Technology, go to:
www.intel.com/info/hyperthreading
To Next Page
Loading...
