MSI 970A

80
RAID Configuration
3. On the Drives Assignments window, use the arrow key to choose the hard
drives which you want to make part of the LD, use the space key to change the
assignment to Y. Then press Ctrl + Y to save the configuration.
4. A message will show, press Ctrl + Y to input a LD name as your desire or press any
key to save default LD name.
5. Another message will show, press Ctrl + Y if you are sure to erase the MBR data of
the disk. Or press any key to ignore this option.
6. The message will show up on the bottom, press any key to use maximum capacity
or press Ctrl + Y to modify array capacity manually.
Important
y The default capacity is the full capacity of the selected hard drives.
y If you allocate the first LD capacity manually, you can create second LD with
remaining capacity of the selected hard drives.