▶U-Key
Enable or disable USB driver device as key. This requires the USB device to be
plugged in for access to the computer..
▶Make U-Key at
When the “U-Key” as sets to [Enabled], this item is selectable. This item allows you to
specify the USB drive.
▶Chassis Intrusion Conguration
Press <Enter> to enter the sub-menu.
▶Chassis Intrusion [Disabled]
This function will be available if the chassis equips a chassis intrusion switch.
Once the chassis is opened, the system will record and issue a warning message.
To clear the warning message, set the item to [Reset], then it will return to
[Enabled] later. [Options: Disabled, Enabled, Reset]
Save & Exit
▶Discard Changes and Exit
Exit BIOS setup without saving any change. This it is used to abandon all changes
and exit BIOS setup.
▶Save Changes and Reboot
This item is used to save all changes and reboot the system.
▶Save Changes
This item is used to save current changes.
▶Discard Changes
This item is used to discard current all changes and restore to the previous values.
▶Restore Defaults
This item is used to restore/ load all default values by the BIOS vendor.
▶Boot Override
The installed boot-able devices will appear on this menu, you can select one of them
be a boot device to start booting.
To Next Page
Loading...
