3-41
Getting Started
Inserting the Disk
The following instructions describe the
general procedure when operating the
optical storage device:
1. Confirm that the notebook is turned on.
2. Touch the EJECT quick launch sensor
and the disk tray will slide out partially.
Please Note: The ODD Eject sensor is
functional under pure DOS system.
However, in an Operating System
without the S-Bar application installed,
the Eject sensor will not be functional.
In such a case, users can right-click the
ODD in "My Computer" and select
"Eject" to eject the ODD tray.
3. Gently pull the tray out until fully
extended.
4. Place your disk in the tray with its label
facing up. Slightly press the center of
the disk to secure it into place.
5. Push the tray back into the drive.
1. Confirm that the disk is
placed correctly and
securely in the tray
before closing the tray.
2. Do not leave the disk
tray open.
5
4
3
2
To Next Page
Loading...
