4 5
Re-pairing
Press and hold the power button for 3 seconds to turn on
the headset.
Press and hold the mute button for 3 seconds until the white
light on the power button starts flashing quickly.
Connect the Wireless USB Transmitter to the PC until its
white light flashes slowly.
Insert a pointed object such as a pin into the hole on the
transmitter and push the button for 2 seconds until the white
light flashes quickly.
The headset will make a sound to indicate that pairing mode
has been entered.
When successfully paired, the white lights on the headset
and Wireless USB Transmitter will stay as a steady white
light.
Battery Life & Charging
To charge the headset: connect the USB-C cable to the
charging port and the other end to a power source.
Charging Status Indicator:
When fully charged, the red light turns off.
When charging, the red light breathes.
When the battery is low, the red light flashes.
Important
1� The maximum input voltage is 5.5V.
2� Chargers labeled with 5V voltage and 500mA current
purchased from official channels are recommended.
3� When the battery is exhausted, please recharge the
headset as soon as possible.
4� It is recommended to fully charge the headset if it is not in
use for a long time.
5� It is recommended to connect the microphone gently to
prevent damage to the connector.
6� Please do not disassemble the product since it may cause
damages.
7� It is recommended to install Nahimic for Headset to
enjoy the best experience with full functionality and
synchronization to the operating system.
To Next Page
Loading...