33
Overview of Components
JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
Normal
(default)
Enabled
(Please enable this jumper
during BIOS POST.)
Important
y
Users will try extreme low temperature (must be higher than -124 degrees to prevent
Debug Code 00) overclocking at their own risks.
y
The overclocking results will vary according to the CPU version.
y
Please don’t set to Enabled when the system is powered off or can’t be started.
T_SEN1~2: Thermal Sensor Connectors
These connectors allow you to connect the thermistor cable and use it to monitor the
temperature of the detection point.
Thermistor cable
GND
Sense
To Next Page
Loading...
