MSI NF750-G55 - Motherboard - ATX - Page 38

2-22
Hardware Setup ▍
MS-7578
Hardware Setup ▍
MS-7578
After the hardware nstallaton s completed, restart the system and nstall the NV
SLI drver/utlty. A con󰘰guraton panel wll be provded for Mult-GPU control. Check
the Enable mult-GPU box to enable the SLI functon for the onboard graphcs cards
(concernng the detals of mult-GPU settngs, please refer to your graphcs card
manual).
2.
Check the box
Restart your system and a pop-up message wll show n the system tray con󰘰rmng
the Mult-GPU has been enabled.
3.
Important
If you want to remove one graphcs card and qut the SLI functon, make sure the
“MultGPU” functon s dsabled.