2-7
OSD Setup
2-6
1st Level Menu 2nd/3rd Level Menu Description
Anti Motion Blur
(OFF)
■ Brightness cannot be adjusted when Anti
Motion Blur is set to ON�
■ When Response Time is set to Fastest with at
least 75Hz Screen Refresh Rate, Anti Motion
Blur will be automatically enabled�
■ When Screen Refresh Rate is lower than
75HZ, Anti Motion Blur cannot be enabled and
Response Time cannot be set to Fastest�
■ When Anti Motion Blur is enabled, HDCR
cannot be enabled and will be grayed out�
■ This function is recommended for cinema, FPS
and Racing games�
■ When FreeSync is enabled, Anti Motion Blur
will be grayed out�
(ON)
Zero Latency
(OFF)
■ Zero Latency default is ON�
■ Zero Latency helps to reduce the signal
throughput timing and supports QHD only�
(ON)
Refresh Rate Location Left Top ■ Users can adjust Refresh Rate in any Mode�
■ Default Refresh Rate Location is Left Bottom�
Location is adjustable in OSD Menu� Press
the Middle Button to conrm and apply your
Refresh Rate Location�
■ This monitor follows and works at the Operating
System’s preset Screen Refresh Rate�
Right Top
Left Bottom
Right
Bottom
OFF
ON
Alarm Clock Location Left Top ■ Users can adjust Alarm Clock in any Mode�
■ After setting the time, press the Middle Button
to activate the timer�
■ Default Alarm Clock Location is Left Top� Users
can select their own location�
Right Top
Left Bottom
Right
Bottom
OFF
15:00 00:01~99:59
30:00
45:00
60:00
Screen
Assistance
None ■ Users can adjust Screen Assistance in any
Mode�
■ Screen Assistance default is None�
FreeSync
(OFF)
■ FreeSync prevents screen tearing�
■ HDMI default is ON but grayed out (cannot be
changed)�
■ DisplayPort default is ON and can be adjusted
ON/OFF in any mode, any resolution, any input
source and any screen refresh rate�
■ When FreeSync is enabled, Anti Motion Blur
will be grayed out�
(ON)
To Next Page
Loading...
