13
OSD Menus
1st Level Menu 2nd/3rd Level Menu Description
MPRT On ∙ Default is off.
∙ When MPRT is enabled,
Brightness cannot be enabled
and will be grayed out.
∙ MPRT and HDCR cannot be
enabled simultaneously.
∙ The MPRT will be disabled and
grayed out when the refresh rate
is lower than 75Hz.
∙ MPRT will be disabled when
Adaptive Sync is enabled.
Off
Input D-Sub (VGA) ∙ Select an Input Source from the
list.
HDMI
Auto Source Off ∙ Default is On.
∙ Users can use the OSD Keys to
select Input Source at below
status:
•While “No Signal” message box
is shown on the monitor.
On
Wide Mode Full ∙ Default is Full.
∙ When set to Full, the resolution
will be stretched to 16:9.
∙ When set to Aspect, the display
will be scaled to the actual
resolution.
Aspect
DDC/CI Off ∙ Default is On.
∙ DDC/CI (Display Data Channel/
Command Interface) is for
remote diagnosis and control.
On
To Next Page
Loading...
