41
BIOS Setup
fCPU Over Voltage Protection [Auto]
Sets the voltage limit for CPU over-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system.
fCPU Under Voltage Protection [Auto]
Sets the voltage limit for CPU under-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system.
fCPU Over Current Protection [Auto]
Sets the current limit for CPU over-current protection. If set to Auto, BIOS will
configure this setting 0utomatically.
fCPU Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU Core voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to Auto, BIOS will configure this setting
automatically.
fCPU VRM Over Temperature Protection [Enabled]
Enables or disables the CPU VRM over temperature protection.
fCPU GT Loadline Calibration Control [Auto]
Sets a specific CPU-GT loadline calibration mode for full-loading system to get
good overclocking performance and stability. If set to Auto, BIOS will configure this
setting automatically.
fCPU GT Over Voltage Protection [Auto]
Sets the voltage limit for CPU GT over-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system.
fCPU GT Under Voltage Protection [Auto]
Sets the voltage limit for CPU GT under-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system.
fCPU GT Over Current Protection [Auto]
Sets the current limit for CPU GT over-current protection. If set to Auto, BIOS will
configure this setting 0utomatically.
fCPU GT Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU GT voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to Auto, BIOS will configure this setting
automatically.
fCPU GT VRM Over Temperature Protection [Enabled]
Enables or disables the CPU GT VRM for over-temperature protection. The CPU GT
frequency may be throttled when VRM temperature over the specified value.
To Next Page
Loading...
