MSI Z270 XPOWER GAMING TITANIUM - PEGSW1: Pcie Ceasefire Switch; J1: OC DASHBOARD Connector

32
Overview of Components
J1: OC DASHBOARD Connector
This connector allows you to connect the OC DASHBOARD with the dedicated OC
DASHBOARD cable.
Reset
OC DASHBOARD
BCLK+
Ratio+
Ratio-
GO2BIOS
OC DASHBOARD
Cable
Slow Mode
Reset
Power
Discharge
BCLK-
Using OC DASHBOARD
OC DASHBOARD provides buttons and switch for overclocking the motherboard. The
components of the OC DASHBOARD are described below.
y BCLK+, BCLK- - these buttons are used to increase or decrease the CPU base clock.
y Reset - press the button to reboot the computer.
y Power - press the button to turn ON/OFF the computer.
y Discharge - allows you to discharge the motherboard to reset BIOS while the
computer is off.
y Ratio+, Ratio- - these buttons are used to increase or decrease the CPU ratio.
y Slow Mode - this switch is used for LN2 cooling solution, that provides the extreme
overclocking conditions, to boot at a stable processor frequency and to prevent the
system from crashing.
y GO2BIOS - press this button to enter BIOS Setup after reboot.
PEGSW1: PCIe CeaseFire Switch
The PCIe CeaseFire switch allows you to enable/ disable the PCIe slots conveniently
and directly.
Slots
ON
1 2 3
ON
1 2 3
ON
1 2 3
ON
1 2 3
PCI_E1 ✓ ✓ ✓ ─
PCI_E2 ✓ ─ ─ ─
PCI_E4 ✓ ✓ ─ ─
(✓: enabled, ─: disabled)