74
BIOS Setup
fCPU Power Duty Control [Thermal Balance]
Selects the method of CPU VRM phase control.
[Thermal Balance] Controls the VRM with thermal balance mode.
[Current Balance] Control the VRM with current balance mode.
fCPU GT Loadline Calibration Control [Auto]
Sets a specific CPU-GT loadline calibration mode for full-loading system to get
good overclocking performance and stability. If set to Auto, BIOS will configure this
setting automatically.
fCPU GT Over Current Protection [Auto]
Sets the current limit on CPU GT for over-current protection. If set to Auto, BIOS
will configure this setting 0utomatically.
[Auto] This setting will be configured automatically by BIOS.
[Enhanced] Extends the current range for over-current protection.
fCPU GT Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU GT voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to Auto, BIOS will configure this setting
automatically.
fCPU GT Power Duty Control [Thermal Balance]
Selects the method of VRM control for CPU GT phase.
[Thermal Balance] Controls the VRM with thermal balance mode.
[Current Balance] Control the VRM with current balance mode.
fDRAM Phase Control [Auto]
Controls memory PWM phase according to the DRAM loading. If set to Auto, BIOS
will optimize the DRAM PWM phase automatically.
[Auto] This setting will be configured automatically by BIOS.
[Optimized] Sets the optimum PWM phase profile.
[Disabled] Disables the PWM phase switching feature.
fDRAM Over Voltage Protection [Auto]
Sets the voltage limit on DRAM for over-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the memory/ system.
fDRAM Under Voltage Protection [Auto]
Sets the voltage limit on DRAM for under-voltage protection. If set to Auto, BIOS
will configure this setting automatically.
fDRAM Over Current Protection [Auto]
Sets the current limit for DRAM over-current protection. If set to Auto, BIOS will
configure this setting automatically.
[Auto] This setting will be configured automatically by BIOS.
[Enhanced] Extends the current range for over-current protection.
To Next Page
Loading...
