55
BIOS Setup
fDRAM Switching Frequency [Auto]
Sets the PWM working speed to stabilize DRAM voltage and minimize ripple range.
Increasing the PWM working speed will cause higher temperature of MOSFET.
So please make sure a cooling solution is well-prepared for MOSFET before you
increase the value. If set to “Auto”, BIOS will configure this setting automatically.
fDRAM VRM Over Temperature Protection [Auto]
Sets the temperature limit on DRAM VRM for over-temperature protection. The
DRAM frequency may be throttled when VRM temperature over the specified value.
If set to Auto, BIOS will configure this settings.
fCPU SA Phase Control [Auto]
Controls PWM phase proportionally to the CPU SA loading.
[Auto] BIOS will set the CPU system agent PWM phase automatically.
[Optimized] Sets the optimum power phase profile, it could provide an optimum
power-saving capability.
[Disabled] Disables the PWM power phase switching feature.
fCPU SA Over Voltage Protection [Auto]
Sets the voltage limit for CPU SA over-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system.
fCPU SA Under Voltage Protection [Auto]
Sets the voltage limit for CPU SA under-voltage protection. If set to Auto, BIOS will
configure this setting automatically.
fCPU SA Over Current Protection [Auto]
Sets the current limit for CPU SA over-current protection.
[Auto] This setting will be configured automatically by BIOS.
[Enhanced] Extends the current range of over-current protection.
fCPU SA Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU SA voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to Auto, BIOS will configure this setting
automatically.
fCPU SA VRM Over Temperature Protection [Auto]
Sets the CPU SA VRM over-temperature protection. The CPU frequency may
be throttled when temperature over the specified value. If set to Auto, BIOS will
configure this settings.
To Next Page
Loading...
