76
BIOS Setup
fDynamic Frequency Search Mode [Once]
Sets the search mode of the dynamic BCLK. This item will be available when the
Dynamic Frequency Search is enabled.
[Once] Run once in the next system boot.
[Each Power On] Run in every time when system is powered on.
fDynamic Frequency Search Step (MHz) [Auto]
Sets the increase for running the dynamic BCLK. If set to Auto, BIOS will configure
this setting automatically. This item will be available when the Dynamic Frequency
Search is enabled.
fBCLK Amplitude [Auto]
Sets the value for BCLK Amplitude for overclocking. Higher value might benefit to
get higher overclocking.
fBCLK Slew Rate [Auto]
Sets the value for BCLK Slew Rate for overclocking. The value might vary
depending on the actual overclocking scenario.
fBCLK ORT Duration [Auto]
Sets the value for BCLK ORT duration for overclocking. The value might vary
depending on the actual overclocking scenario.
f Extreme Memory Profile (X.M.P.) [Disabled]
X.M.P. (Extreme Memory Profile) is the overclocking technology by memory module.
Please enable XMP or select a profile of memory module for overclocking the memory.
This item will be available when the memory modules that support X.M.P. is installed.
f DRAM Reference Clock [Auto]*
Sets the DRAM reference clock. The valid value range depends on the installed CPU.
This item appears when a CPU that supports this adjustment is installed.
f DRAM Frequency [Auto]
Sets the DRAM frequency. Please note the overclocking behavior is not guaranteed.
f Adjusted DRAM Frequency
Shows the adjusted DRAM frequency. Read-only.
f Load Memory Presets [Disabled]*
Load OC Memory Preset will optimize the timing, voltage of installed memory module.
Important
Manual tweaking or fine-tune preferred parameter is still recommended due to
different memory module manufacturing quality.
f Memory Try It ! [Disabled]
It can improve memory compatibility or performance by choosing optimized memory
preset.
To Next Page
Loading...
