78
BIOS Setup
fCPU Over Current Protection [Auto]
Sets the current limit for CPU over-current protection. If set to Auto, BIOS will
configure this setting automatically.
[Auto] This setting will be configured automatically by BIOS.
[Enhanced] Extends the current range for over-current protection.
fCPU Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU Core voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to Auto, BIOS will configure this setting
automatically.
fCPU VRM Over Temperature Protection [Auto]
Sets the temperature limit on CPU VRM for over-temperature protection. The CPU
frequency may be throttled when CPU temperature over the specified temperature.
If set to Auto, BIOS will configure this settings.
fCPU Power Duty Control [Thermal Balance]
Sets the current of every VRM phase and the thermal conditions of every phase
component.
[Thermal Balance] Maintains the VRM thermal balance.
[Current Balance] Maintains the current VRM balance.
fDRAM Phase Control [Auto]
Controls PWM phase proportionally to the DRAM loading.
[Auto] This setting will be configured automatically by BIOS.
[Optimized] Sets the optimum PWM phase profile.
[Disabled] Disables the PWM phase switching feature.
fDRAM Over Voltage Protection [Auto]
Sets the voltage limit for DRAM over-voltage protection. If set to Auto, BIOS will
configure this setting automatically. Higher voltage provides less protection and
may damage the system/ memory.
fDRAM Under Voltage Protection [Auto]
Sets the voltage limit for DRAM under-voltage protection. If set to Auto, BIOS will
configure this setting automatically.
fDRAM Over Current Protection [Auto]
Sets the current limit for DRAM over-current protection. If set to Auto, BIOS will
configure this setting automatically.
[Auto] This setting will be configured automatically by BIOS.
[Enhanced] Extends the current range for over-current protection.
fDRAM Switching Frequency [Auto]
Sets the PWM working speed to stabilize DRAM voltage and minimize ripple range.
Increasing the PWM working speed will cause higher temperature of MOSFET.
So please make sure a cooling solution is well-prepared for MOSFET before you
increase the value. If set to “Auto”, BIOS will configure this setting automatically.
To Next Page
Loading...
