MSI Z97-G45 GAMING - CPU and DRAM Settings

English
En-33
< CPU BCLK Setting >
CPU Base Clock (MHz) [Default]
Sets the CPU Base clock. You may overclock the CPU by adjusting this value. Please
note that overclocking behavior and stability is not guaranteed. This item appears when
the installed processor supports this function.
< DRAM Setting >
DRAM Reference Clock [Auto]*
Sets the DRAM reference clock. The valid value range depends on the installed CPU.
This item appears when a CPU that supports this adjustment is installed.
DRAM Frequency [Auto]
Sets the DRAM frequency. Please note the overclocking behavior is not guaranteed.
Adjusted DRAM Frequency
Shows the adjusted DRAM frequency. Read-only.
Extreme Memory Pro󰘰le (X.M.P) [Disabled]
X.M.P. (Extreme Memory Pro󰘰le) is the overclocking technology by memory module.
This item will be available when you install the memory modules that support X.M.P.
technology.
[Disabled] Disables this function.
[Pro󰘰le 1] Uses pro󰘰le1 over-clocking settings of installed XMP memory module.
[Pro󰘰le 2] Uses pro󰘰le2 over-clocking settings of installed XMP memory module.
DRAM Timing Mode [Auto]
Selects the memory timing mode.
[Auto] DRAM timings will be determined based on SPD (Serial Presence Detect)
of installed memory modules.
[Link] Allows user to con󰘰gure the DRAM timing manually for all memory
channel.
[UnLink] Allows user to con󰘰gure the DRAM timing manually for respective
memory channel.
Advanced DRAM Con󰘰guration
Press <Enter> to enter the sub-menu. This sub-menu will be activated after setting [Link]
or [Unlink] in “DRAM Timing Mode”. User can set the memory timing for each memory
channel. The system may become unstable or unbootable after changing memory tim-
ing. If it occurs, please clear the CMOS data and restore the default settings. (Refer to
the Clear CMOS jumper/ button section to clear the CMOS data, and enter the BIOS to
load the default settings.)
Memory Fast Boot [Auto]
Enables or disables the initiation and training for memory every booting.
[Auto] This setting will be con󰘰gured automatically by BIOS.
[Enabled] Memory will completely imitate the archive of 󰘰rst initiation and 󰘰rst
training. After that, the memory will not be initialed and trained when
booting to accelerate the system booting time.
[Disabled] The memory will be initialed and trained every booting.
< Voltage Setting >
DigitALL Power
Press <Enter> to enter the sub-menu. Controls the digital powers related to CPU
PWM.
▶
▶
▶
▶
▶
▶
▶
▶
▶