MSI Z97-GD65 - Page 86

Chapter 3
3-22BIOS Setup
CPU Over Current Protection [Auto]
Sets the current limit for CPU over-current protection.
[Auto] This setting will be con󰘰gured automatically by BIOS.
[Enhanced] Extends the limitation of CPU over-current protection.
CPU Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU Core voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to "Auto", BIOS will con󰘰gure this setting
automatically.
CPU VRM Over Temperature Protection [Auto]
Sets the temperature limit on CPU VRM for over-temperature protection. The CPU
frequency may be throttled when CPU VRM over the speci󰘰ed temperature. If set
to "Auto", BIOS will con󰘰gure this settings.
CPU Power Duty Control [Thermal Balance]
Selects the method of VRM control for CPU phase.
[Thermal Balance] Control the VRM with thermal balance mode.
[Current Balance] Control the VRM with current balance mode.
DRAM Phase Control [Auto]
Controls PWM phase proportionally to the DRAM loading. If set to "Auto", BIOS
will optimize the DRAM PWM phase automatically.
[Auto] This setting will be con󰘰gured automatically by BIOS.
[Normal] Sets the normal power phase pro󰘰le.
[Optimized] Sets the optimum power phase pro󰘰le.
[Disabled] Disables the PWM power phase switching feature.
DRAM Vdroop Offset Control [Auto]
Sets a percentage of o󰘯set voltage for DRAM vdroop. If set to "Auto", BIOS will
con󰘰gure this setting automatically.
DRAM Over Voltage Protection [Auto]
Sets the voltage limit for DRAM over-voltage protection. If set to "Auto", BIOS will
con󰘰gure this setting automatically. Higher voltage provides less protection and
may damage the system.
DRAM Under Voltage Protection [Auto]
Sets the voltage limit for DRAM under-voltage protection. If set to "Auto", BIOS
will con󰘰gure this setting automatically. Higher voltage provides less protection and
may damage the system.
DRAM Over Current Protection [Auto]
Sets the current limit for DRAM over-current protection.
[Auto] This setting will be con󰘰gured automatically by BIOS.
[Enhanced] Extends the limitation of CPU over-current protection.
DRAM Switching Frequency [Auto]
Sets the PWM working speed to stabilize DRAM voltage and minimize ripple range.
If set to "Auto", BIOS will con󰘰gure this setting automatically.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶