MSR MSR605 - Page 13

MSR6 05 Programmer ’ s Manual Rev. A
10
22. Command: Set Low-Co
Command code: <ESC> y
Hex code: 1B 79
Response: <ESC> 0
Description: This command is used to set MSR605 status to write Low-Co card.
23. Command: Get Hi-Co or Low-Co status
Command code: <ESC> d
Hex code: 1B 64
Response: <ESC> H -------to write Hi-Co
: <ESC> L ------- to write Low-Co
Description: This command is to get MSR605 write status.