EasyManua.ls Logo

MST 5700 - Page 13

Default Icon
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
MODEL 5700
C. CONTINUOUS OPERATION ADAPTER (12 VDC) - P/N 80123
This accessory will allow the use of an external 12 volt DC battery, such as an
automotive or compressor battery, to provide continuous operation of the instrument.
Care must be taken to observe that the proper voltage (12 VDC) and polarity (Red
clip is
positive, Black clip is negative) is maintained.
.
WARNING: FAILURE TO OBSERVE PROPER POLARITY AND/OR PROPER
VOLTAGE COULD RESULT IN PERSONAL INJURY, DAMAGE TO THE INSTRUMENT
AND VOIDING OF WARRANTY.
D. RECHARGEABLE BATTERY PACK (12 VDC) P/N 8013501
This battery is used where the instrument is to be operated for a prolonged time without
AC power. The Rechargeable Battery System consists of a 12 Volt, 4.5 Amp-Hour
sealed lead acid-type battery enclosed in a 4.75" W x 4.75" H x 3.7" D protective plastic
housing, UL listed 12 Volt DC, 200 mA charger (P/N 80135) and connecting cord (P/N
8038301) to allow the system to be connected to the instrument.
1. Plug connecting cord (P/N 8038301) from battery into instrument’s socket located
on lower right-hand side.
2. A fully charged battery (24 hour charge time) should power the instrument up to
250 hours.
3. Since the voltage of the Rechargeable battery is slightly higher than that of the 2
internal 9-Volt transistor type batteries, the rechargeable battery will supply the
power when connected. Blocking diodes protect the internal 9-Volt transistor-
type batteries.
E. REMOTE EXTERNAL ALARM/STROBE - P/N 8066901
This accessory is a piezoelectric audible alarm (110 dB (A) at 10 ft.) with a 20 Ft. cord that
plugs into the REM of the instrument. This alarm can be supplied with up to 250 Ft. of cord.
F. REMOTE EXTERNAL STROBE - P/N 8008503
(The continuous operation adapters, P/N 80247 or 80123, must be used in conjunction with
this accessory due to voltage requirements).
This accessory is a 150,000 CP strobe with a flash rate of 60 per minute. The operating life
of this strobe is 800 hours. The strobe comes with a 20 ft. cord that plugs into the REM of
the instrument. This alarm can be supplied with up to 250 Ft. of cord.